Installation Instructions

The Micky Ha Ha Power Point Safety Covers come complete with two adhesive strips located on the top and bottom of the base. To attach, detach the cover from the base, peel off the red outer tape cover and firmly press the base onto a cleaned and dried flat wall surface (not suitable for installation on uneven surfaces or brick walls). The adhesive increases in strength over time so do not attach the cover to the base and do not touch the base for at least 3 days while the tape cures. 

There is a hole in both the top and bottom of the base so the unit can be screwed to the wall. The cover should be attached using both the tape and screws for maximum strength.

The cover can be turned so cords can be directed out either the top or bottom. Perfect for higher power points such as air conditioner plugs to stop cords dangling.